Dual 4'' Two-Way Center-Channel Satellite Loudspeaker
RCX-4
The RCX-4 is a low-profile, horizontally
oriented center channel loudspeaker. Although
designed primarily to work with the RSX-4 and
I
Very high sensitivity
MicroTractrix Horn tweeter for clean, detailed highs
Dual Cerametallic cone woofers in a Tapered Array configuration to
I
I
RSX-5 Reference Satellites, which it matches
maximize clarity
perfectly both cosmetically and sonically, the
I
Ball-joint pedestal stand with keyholes allows easy placement
RCX-4’s sound also blends well with that of
I
Magnetically shielded to prevent video interference
other Klipsch loudspeakers, allowing
maximum flexibility in system configuration. Its
gracefully contoured, high-rigidity enclosure
fits easily on any television set, or it can be
S P E C I F I C A T I O N S
shelf-, wall-, or ceiling-mounted. An integrated
ball-joint pedestal stand with bottom keyholes
makes it easy to place the RCX-4 on any
convenient surface and direct its sound into
the listening area.
BANDWIDTH
92Hz-20kHz 3dB
94dB @ 2.83 volts/1 meter
8 ohms compatible
2100Hz
SENSITIVITY
NOMINAL IMPEDANCE
CROSSOVER FREQUENCY
POWER HANDLING
High frequencies emanate from a 1-inch
titanium dome compression driver tweeter.
The round MicroTractrix™ Horn molded into
the front of the cast aluminum baffle raises the
driver’s efficiency and controls its radiation
pattern to minimize detail-blurring reflections
from walls, floor, and ceiling. Flanking the
tweeter are twin 4-inch Cerametallic™cone
woofers operating as a Tapered Array. Klipsch
Tapered Array™ Technology operates both
woofers at the lowest frequencies and only
one all the way up to the point where the
tweeter takes over, eliminating the destructive
middle-frequency interference between
woofer outputs characteristic of ordinary
woofer-tweeter-woofer lineups. Low-
frequency response extends deep enough to
mesh seamlessly with the crossovers built into
A/V receivers, surround processors, and
powered subwoofers. All drivers are
magnetically shielded to prevent interference
with direct-view television sets. As in all
Reference Series loudspeakers, premium
crossover components ensure optimum signal
transfer.
75 watts (300 watts peak)
ENCLOSURE TYPE
DRIVE COMPONENTS
Bass reflex via dual rear-firing ports
Two-way system using one 1'' (2.5cm)
magnetically shielded, titanium dome
compression driver tweeter with an integral
round 90˚ MircroTractix Horn and two 4''
(10.2cm) magnetically shielded, Cerametallic
cone woofers
WEIGHT
HEIGHT
WIDTH
DEPTH
7.5 lbs. (3.4kg) including base
7.5" (19cm) including base, 5.4" w/out base
14.8" (37.6cm)
8.4" (21.3cm)
FINISH
MOUNTING
Black or Silver
Base swivels 360˚ for on-wall mounting via
keyholes
Because of its high power-handling capability
and unusually high sensitivity, the RCX-4 can
sustain significantly higher output than most
similar-size center speakers. And though
ideally suited for use with other Klipsch
loudspeakers, it will provide excellent center
channel sound in any system.
1-800-KLIPSCH
All specifications are subject to change without notice. ©2004
|
Infinity Speaker Beta Tendvc User Manual
IOGear Mouse M1308 User Manual
Jasco Switch HO97864 User Manual
Jensen Automobile Accessories BT 390 User Manual
JVC DVD Player RX DV31 User Manual
JVC Projector Accessories LCT2662 001A User Manual
Kalorik Egg Cooker GR38892 User Manual
KitchenAid Food Processor K5 A User Manual
Kramer Electronics Laser Pointer VP 719xl User Manual
Kramer Electronics Stereo Amplifier 106 User Manual