Klaxon Network Card 102325 User Manual

Installation Instructions

Flashguard LED Flasher Module

To Flashguard Xtra

Straighten the two LEDs by gently bending them in to

the upright position.

Peel the backing off the adhesive mounting brackets

provided and attach them to the inside of the cover as

shown below.

6 cm

Connect the unit to a suitable 12V supply, observing

polarity. The two LEDs will now flash alternately.

Slot the PCB into the mounting brackets with the LEDs

pointing towards the lens. Bend the LEDs into position if

required.

Fix the unit to the wall in the same way as an ordinary

simulated unit.

Wrigley Street, Oldham, Lancashire. OL4 1HW

Tel +44 (0)161 287 5555 Fax +44 (0)161 287 5511