Ingersoll Rand Heat Pump 67165 X User Manual

OPERATOR’S MANUAL  
67165-X  
67166-X  
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE  
67277-X  
SOLENOID ACTUATED PUMP KITS  
RELEASED:  
REVISED:  
(REV. G)  
3-6-98  
3-7-06  
FOR DIAPHRAGM PUMPS  
SOLENOID ACTUATED PUMP KITS  
GENERAL DESCRIPTION  
67165-( ) for 3/8" and 1/2" diaphragm pumps, as follows:  
66605X-X, PD03P-X-X, PD05P-X-X, PD05P-X-X-B, PD05R-X-X-B  
and PM05P-X-X-A02.  
67166-( ) for 1", 1-1/2" and 2" non-metallic diaphragm pumps as follows:  
6661AX-X-C, 6661BX-X-C, 6661TX-X-C, 6661UX-X-C, 6662AX-X-C  
and 6662BX-X-C.  
67166-( ) for 1" and 1-1/2" metallic diaphragm pumps as follows:  
66610X-X-C, 66611X-X-C, 66612X-X-C, 66613X-X-C, 66615X-X-C,  
66616X-X-C, 66617X-X-C and 66618X-X-C.  
ARO solenoid actuated diaphragm pump kits allow the cycle rate of the  
pump to be controlled electronically. When the solenoid is energized, the  
pump strokes and dispenses the fluid in one chamber. When the sole-  
noid is de-energized, the pump strokes in the opposite direction, dis-  
pensing the fluid in the other chamber.  
By providing continuous ON - OFF signals to the solenoid, the fluid  
transfer rate may be increased or decreased remotely.  
Some parts of the pump must be replaced with those included in these  
kits to enable solenoid actuation.  
67277-( ) for 2" and 3" metallic diaphragm pumps as follows:  
PD20A-X-X, PF20A-X-X, PM20A-X-X-A02, PD30A-X-X-B and  
PM30A-X-X-B02.  
67165-( ) SOLENOID KIT INSTALLATION  
3/8” AND 1/2” DIAPHRAGM PUMPS  
Refer to figure 1.  
1. Remove (134) bolts from the major valve and remove (135) valve  
block.  
2. Remove (136) plug and replace with 93909 or 96462 plug.  
3. Place 94640 plug in pilot hole.  
4. Attach (135) valve block to (101) motor body, using (133) washers  
and (134) bolts. NOTE: Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).  
5. Thread CAT33P-( )-( ) valve assembly into air supply port.  
6. Connect CAT33P-( )-( ) valve with 93909 plug, using 94981-XXX-X  
tube.  
Identification dot this side.  
132  
135  
141 k  
140  
~ Valve  
(see table)  
~ 676  
~ 59756-4  
~ 90351  
133  
96214-2 ~  
94640 ~  
. 134  
136  
Y325-125 ~  
~ Y325-29  
93909 ~  
~ 94981-XXX-X  
(5" long) g  
59756-4 ~  
~ 96462  
NOT SHOWN  
CHW Connector  
~ 59756-4  
k Assemble with 2 identification dots toward (132) gasket.  
.Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).  
~ Supplied with 67165-( ) Kit.  
Z See page 4 for coil options.  
g 94981-XXX-X Bulk Tubing (100’ long).  
MODEL  
67165-1 CAT33P-024-D  
VALVE  
VOLTAGE  
24 VDC  
67165-2 CAT33P-120-A 120 VAC  
67165-3 CAT33P-000-N No Coil Z  
Figure 1  
INGERSOLL RAND COMPANY LTD  
P.O. BOX 151 D ONE ARO CENTER D BRYAN, OHIO 43506-0151  
& (800) 276-4658 D FAX (800) 266-7016  
E2006  
CCN 99711780  
 
67277-( ) SOLENOID KIT INSTALLATION  
2” & 3” METALLIC DIAPHRAGM PUMPS  
Refer to figure 3.  
1. Remove (134) screws and (133) washers, and remove (135) valve  
block and components from (101) center body.  
2. Attach 67277-( ) solenoid kit assembly to (101) center body, using  
(134) screws and (133) washers. NOTE: Torque screws to 40 - 50 in.  
lbs (4.5 - 5.6 Nm).  
.Torque to 40 - 50 in. lbs (4.5 - 5.6 Nm).  
Z See page 4 for coil options.  
~ Included in 67277-( ) Kit.  
101  
~ 29670 Ball  
133  
67277-( )  
. 134  
135  
43  
Figure 3  
67277-( ) PARTS LIST  
119380 Coil Nut  
116218-( ) Coil (see table)  
114102 Valve System  
114104 ꢀO" Ring (1.5 mm x 14.5 mm o.d.)  
114103 ꢀO" Ring (1.5 mm x 5.5 mm o.d.)  
Y147-16-C Retaining Ring (1.804" o.d.)  
94728 Solenoid Plug  
Y325-126 ꢀO" Ring (2) (3/32" x 1-9/16" o.d.)  
92011 Piston  
Y186-51 ꢀU" Cup (3/16" x 1-3/8" o.d.)  
94032-1 Valve Block  
92005 Spool  
92876 Spacer (4)  
Y325-214 ꢀO" Ring (5) (1/8" x 1-1/4" o.d.)  
Y325-126 ꢀO" Ring (6) (3/32" x 1-9/16" o.d.)  
92877 Washer (5)  
NOT SHOWN  
CHW Connector  
Y16-203 Ball (2) (3/32" dia, press flush w/94032-1)  
96728647 Cap Screw (2) (M3 - .5 x 18)  
94027 Spacer  
MODEL VOLTAGE COIL  
67277-1 24 VDC 116218-39  
67277-2 120 VAC 116218-33  
94034 Inlet Plug  
67277-3 No Coil Z  
Figure 4  
67165-X  
Page 3 of 4  
 
DISPLACEMENT PER CYCLE  
Specific Gravity = 1.000  
Models  
Gallons  
0.022  
Ounces  
2.815  
in.#  
5.082  
cc  
Liters  
0.083  
Grams  
83  
Kg  
0.083  
3/8" Non-Metallic − PD03P-X-X  
1/2" Non-Metallic Duck Bill − 66605X-0XX  
1/2" − PD05P-X-X-B, PD05R-X-X-B  
1/2" − 66605X-X, PD05P-X-X, PM05P-X-X-A02  
1" Non-Metallic − 6661AX-X-C, 6661BX-X-C  
83  
121  
148  
151  
643  
606  
0.032  
0.039  
0.040  
0.170  
0.160  
4.095  
4.991  
7.392  
9.009  
0.121  
0.148  
0.151  
0.643  
0.606  
121  
148  
151  
643  
605  
0.121  
0.148  
0.151  
0.643  
0.605  
5.119  
9.240  
21.756  
20.476  
39.270  
36.960  
1" Metallic − 66610X-X-C, 66611X-X-C, 66612X-X-C,  
66613X-X-C  
1-1/2" Non-Metallic − 6661TX-X-C, 6661UX-X-C  
0.670  
0.640  
85.743  
81.903  
154.770  
147.840  
2536  
2422  
2.536  
2.422  
2534  
2421  
2.534  
2.421  
1-1/2" Metallic − 66615X-X-C, 66616X-X-C, 66617X-  
X-C, 66618X-X-C  
2" Non-Metallic − 6662AX-X-C, 6662BX-X-C  
2" Metallic − PD20A-X-X, PF20A-X-X, PM20A-X-X-A02  
3" Metallic − PD30A-X-X-B, PM30A-X-X-B02  
0.720  
1.400  
2.800  
92.141  
179.164  
358.327  
166.320  
323.400  
646.800  
2725  
5299  
2.725  
5.299  
2723  
5296  
2.723  
5.296  
10,598  
10.598  
10,591  
10.591  
2 strokes per complete cycle - 1" metallic will displace 0.080 gallons per stroke.  
COIL OPTIONS  
Coil Number  
50 / 60 Hz  
12  
DC  
116218-31  
116218-33  
116218-35  
116218-37  
116218-38  
116218-39  
120  
240  
5
24  
48  
12  
24  
PN 97999-760  
67165-X  
Page 4 of 4  
 

Infantino Baby Carrier TravelTrio Shopping Cart Cover User Manual
Ingersoll Rand Air Compressor 2115Ti User Manual
Ingersoll Rand Heat Pump LM2203AX User Manual
Insignia Film Camera NS 13T001 User Manual
iRobot Vacuum Cleaner 320 User Manual
JBL Portable Speaker FM52 User Manual
Jenn Air Appliance Trim Kit W10295557D User Manual
Jensen MP3 Docking Station JiMS 190 User Manual
John Deere Water Pump AC CP2GH User Manual
Kenmore Sewing Machine 19005 User Manual